Products

Products :: Test & Measurement :: Wire & Cable Harness

Wiring Analyzers

The modular design of DIT-MCO’s automated wiring analyzers offer you customization at the price of an off-the-shelf system. Your test application determines the test and measurement accuracies needed, switching type, size, portability, and throughput. Each system comes complete with the capability to test:

• Circuit continuity tests for open circuits
  
• Insulation resistance verification for short circuits
  
• Dielectric breakdown (hipot) tests
  
• Resistor tests
  
• Relay tests
  
• Diode tests
  
• Capacitor tests
  
• Switch and circuit breaker tests

You can program measurements in high-resolution steps from 0.01 ohm to 1000 megohms, program voltage stimuli as well from .225 volt through 2000 volts and current from 5 milliamps through 2 amp.

DIT-MCO has a test system that is right for your application. This summary helps you decide which system will meet your needs:

Benchtop Models:

• Model 2115 - up to 1,000 test points (expansion available)
  
• Model 2135 - up to 300 test points (less than 30 pounds)
  
• Model 2175 - NSN 2175 SBC–0500-1001

Multi-Bus Architecture:

• Model 2500.MBA - up to 10 independent buses to actuate components

High Voltage:

• Model 2500.HVA - stimulus voltages of 2000VDC and 2000VAC

Distributed Switching:

• Model 2650.MTA - eliminate costly adapters by bringing switching unit to product

Point Count Considerations:

• Model 2503 - up to 10,000 test points per enclosure
  
• Model 2505 - up to 5,000 test points per enclosure
  
• Model 2508 - utilizes high density switching for up to 15,000 test points per enclosure